Viperteks wrote:Because it has 'M16' in it's title so it is a 'Black' knife and a 'Assault' knife, all the 'Mall Ninjas' will buy it...
Personally I don't like it at all, especially the Tanto blade
Dave
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
flintlok wrote: You could do lots worse
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
leadpig wrote:flintlok wrote: You could do lots worse
but you can do a lot better
flintlok wrote:leadpig wrote:flintlok wrote: You could do lots worse
but you can do a lot better
In a commercial grade knife????
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
Yessir wrote:Don't know about ontario but the other four produce a range of chinese made low end knives to Dave . You can usually tell by the price tag , so in fairness without spending more on the higher end models by Spyderco etc then your not going to do much better for the money. I.e. the spyderco BYRD knives are a similar price but certainly no better than CRKTs. I use BYRDs for edc as they are good enough for cutting plastics but its no big deal when they inevitably get lost. I've lost 3 in the past 5 or so years, and snapped one from abusing it.
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
flintlok wrote:Dave, you can get a CRKT M16 Folding Knife with a traditonal point in AUS 8 stainless steel blade.
I know that I'm being a pest .......
http://www.crkt.com/M1603Z?vm=r
Sidebyside wrote:Leadpig is probably right,( though I hate to admit that ) .
Fenrir wrote:It is often better to let people think you are a bit simple rather than removing all doubt.
Return to Knives, axes, other cutting tools and sharpening
Users browsing this forum: No registered users and 8 guests