Ammunition reloading for centerfire or shotgun
Forum rules
Shooters using reloading info and load data in this forum do so at their own risk. Check all loads with printed, commercially available reloading manuals and NEVER exceed maximum powder weights. The board/forum accepts NO liability for accidents! Be careful!
Sat Oct 13, 2018 11:41 am
hi. I made a annealer with a pencil torch. I have the feeling the annealing went totally wrong only till the half of the shoulder is a colour change. Who can help me and tell me if they are ok or not. See picture. If it is done wrong; can I do it again now before these cases have been fired?
Wed Jun 03, 2020 6:23 am
You can redue them. The bottom of the blue band that is in the middle of the shoulder should be about 1/2" below the shoulder.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.