Guys
Moving on in the saga of Foxyfils first reloading escapade.
I made up my first batch of bullets for testing today.
I made up 5 batches of 8, each batch with differing powder weights , all within the limits, as recommended by Sierra, the bullet of choice for this batch.
Every now and then, I rolled one or two of them on the flat bench, and it would appear that the bullets are crooked. I ran them thru the press again to no avail. Its not much, but its definitely visible
These are once fired Hornady cases, and brand new RCBS dies, Full Length Sizing and Seating.
Any advice on why the bullets aren't seating straight?
Has the sizing die bent the necks, or is the seating die faulty?
I'm in a dilemma now whether or not I can discharge the rounds through the rifle in case it damages the gun, or worse, me!!